Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC ...

The customer has questions about TLC6C5712-Q1. The purpose is to optimize the number of connecting pins between the MCU and the LED DRIVER. Can I open the PWM0-5 PIN? The system requirements are as ...

Other Parts Discussed in Thread: SN65LVP20, Hello, would the SN65LVP17 or SN65LVP20 be suitable to convert 2.5V LVDS to LVPECL using the VBB pin and common mode biasing resistors? How would one ...

We have got a question about testing method of voltage ripple. We currently use TPS6281220QWRWYRQ1 as voltage supply for a serializer chip DS90UB983RTDRQ1, which has strict requirement with supply ...

Other Parts Discussed in Thread: OPA187, We have been using the OPA188 in a number of new development and pre-production projects. We have obtained the OPA188 from three different sources and they all ...

I am an software engineer and working on a project with the TMS570LS1224 MCU. I am trying to use pull up and pull down in input mode, and open drain and push pull in output mode using GIO pins. I want ...

We purchased the parts of PS659118A2ZRC from Rochester, and under the X-RAY, the sizes of solder balls are different. While the appearance is not noticeable Pls check the below picture for details.

Customer got older version chip, the hardware version is 0x0A and firmware version is 0x04. Their golden sample was based on hardware version 0xa2 and firmware version 0x05. Could they direct ...

We planned to use MIPI CPHY CSI interface. With respect to Layout routing of the CPHY CSI signals, Is that all trios can be routed as single ended or differentiality to be maintained like DPHY routing ...

I have the following questions about the parts in BOM list of AWR1843AOPEVM board(PROC106B) you provide. 1) The automotive grade parts(Capacitors, Inductors ...

I was looking at this thread LM7480-Q1: Reason for bidirectional vs unidirectional TVS diode on the input side - Power management forum - Power management - TI E2E support forums regarding usage of ...

We have found that the same bq40z50 exhibits inconsistent response times during testing. Sometimes data is received immediately, while other times there is a delay 2~4 seconds. Please provide the ...